User Manual

MONTAGE Supplementary Manual
31
Strength
Sets the degree or “magnetic strength” to which Quantize is applied. A setting of 100% produces exact timing. A setting of 0%
results in no quantization.
Range: 0% – 100%
Swing Rate
This selectively delays the notes on even-numbered beats (backbeats) to produce a swing feel. For example, if the meter is 4/4
and the Quantize value is quarter notes, the 2nd and 4th beats of the measure will be delayed.
Settings: Depends on specified Quantize value
If the Quantize value is 1/4 note, 8th note, 16th note, 32nd note: 0 – half of the triplet grid
If the Quantize value is 1/4 note triplet, 8th note triplet, 16th note triplet: 0 – half of the triplet grid
If the Quantize value is 8th note + 8th note triplet, 16th note + 16th note triplet: 0 – half of the triplet grid
Gate Time
Determines the gate time (the length of time a note sounds) of the even-numbered backbeat notes for enhancing the swing feel.
Range: 0% – 200%
Execute
Executes the Job on the MIDI sequence data.
This Job alters the velocity values of a specified range of notes, letting you selectively boost or cut the volume of those notes.
NOTE Velocity changes are calculated as follows
Adjusted Velocity = (Original Velocity x Rate) + Offset
If the result is 0 or less, the value is set to 1. If the result is higher than 127, the value is set to 127.
Set All
Sets the velocities of all target notes to the same fixed value. When set to “Off,” the Set All parameter has no effect. When set to
a value other than “Off,” the Rate and Offset parameters are unavailable.
Range: Off, 001 – 127
Rate
Determines the percentage by which the target notes will be shifted from their original velocities. Range below 100% reduce the
velocities, and Range above 100% increase the velocities proportionately. When the Set All parameter is set to something other
than “Off,” this parameter cannot be changed.
Range: 0% – 200%
Velocity
Operation
[R] (Play) button or [PERFORMANCE]  [Play/Rec]  [Pattern]  [Edit/Job]  [Note]  [Velocity]