User Manual
Table Of Contents
- Contents
- New Functions in MONTAGE Version 3.50
- New Functions in MONTAGE Version 3.00
- New Functions in MONTAGE Version 2.50
- New Functions in MONTAGE Version 2.00
- New Functions in MONTAGE Version 1.60
- New Functions in MONTAGE Version 1.50
- New Functions in MONTAGE Version 1.20
- New Functions in MONTAGE Version 1.10
MONTAGE Supplementary Manual
73
Control Assign dialog
In the dialog displayed when the Part parameter is selected and the [CONTROL ASSIGN] button is pressed, you can now select
the Assignable Knob of Common by operating the Assignable knob by pressing the [PART COMMON].
While pressing the [PART COMMON] button, operate the Knob you wish to use when operating the target parameter.
NOTE An error message appears when you turn the Super Knob and there are no more Assignable Knobs or Control Assigns available for
assigning a Source.
Operation
Point the cursor to the control destination parameter of the Part Press the [CONTROL ASSIGN] button.