User Manual
Table Of Contents
- Contents
- New Functions in MONTAGE Version 3.50
- New Functions in MONTAGE Version 3.00
- New Functions in MONTAGE Version 2.50
- New Functions in MONTAGE Version 2.00
- New Functions in MONTAGE Version 1.60
- New Functions in MONTAGE Version 1.50
- New Functions in MONTAGE Version 1.20
- New Functions in MONTAGE Version 1.10
MONTAGE Supplementary Manual
86
Control Assign dialog
You can now select the Super Knob, Motion Sequencer Lane, or Envelope Follower as a source in the dialog that appears when
the [CONTROL ASSIGN] button is pressed.
Operate the controller you want to set as a Destination parameter or touch a number under “Motion Sequencer Lane” or
“Envelope Follower.”
NOTE An error message appears when you turn the Super Knob and there are no more Assignable Knobs available for assigning a Source.
Operation
Press the [CONTROL ASSIGN] button when the cursor is on the parameter to be the control destination.