User Manual

MONTAGE Supplementary Manual
91
Common/Audio Edit (Common/Audio)
You can now set Super Knob to “Display Filter.” You can also check the parameters for Parts which are controlled by using
Assignable Knobs common to all Parts in this display.
Display Filter
Determines the Controller to be displayed. When “Super Knob” is selected, all Assignable Knob settings in which “Super Knob
Link” is set to On are displayed.
Settings: AsgnKnob 1 – 8, Super Knob, MS Lane 1 – 4, EnvFollow 1 – 16, EnvFollowAD, EnvFollowMst, All
The following parameters are displayed only when “Destination 1 – 16” is set to “Part 1 – 16 Assign 1 – 8.” Also, when
Destination is not set to any Assignable Knobs for the Part, only the shortcut buttons are available.
Destination
Determines the controller settings for the Part to be displayed.
Settings: 1 – 16 (The number of Destinations for the Assignable Knobs for the Part which is selected in “Destination 1 – 16” is displayed.)
Parameter
Determines the parameters for the Part to be controlled.
Settings: Refer to the “Control List” in the Data List.
Edit Part Control Settings
Calls up the Control Assign display for the currently selected Part.
Curve Type
Determines the specific curve for changing the parameter which is set in “Destination.” The horizontal axis indicates the value of
the controller set in “Source” and the vertical axis indicates the parameter values.
Settings: Standard, Sigmoid, Threshold, Bell, Dogleg, FM, AM, M, Discrete Saw, Smooth Saw, Triangle, Square, Trapezoid, Tilt Sine, Bounce,
Resonance, Sequence, Hold
For User Bank: User 1 – 32
When a Library file is read: Curves in Library 1 – 8
Control
Control Assign
Operation
[PERFORMANCE]  [EDIT]  PART [COMMON]  [Control]  [Control Assign]
or
Touch [Edit Super Knob] in the Super Knob display.
Display Filter