User Manual

Edit Search Utility Live SetPerformance
Normal Part (AWM2) Drum Part Normal Part (FM-X) Common/Audio
MONTAGE Reference Manual
Normal Part (AWM2) Edit
Common
Part Settings
General
Pitch
Zone Settings
Zone Transmit
Effect
Routing
Ins A
Ins B
EQ
Arpeggio
Common
Individual
Advanced
Motion Seq
Common
Lane
Mod / Control
Part LFO
Control Assign
Receive SW
Element
Osc / Tune
Pitch EG
Filter
Type
Filter EG
Scale
Amplitude
Level / Pan
Amp EG
Scale
Element LFO
Element EQ
All Element
Osc
Balance
68
Reference
Ins Connect (Insertion Connection Type)
Determines the effect routing for Insertion Effects A and B. The setting changes are shown on the diagram
in the display, giving you a clear picture of how the signal is routed. For details, see the section “Effect
connection” (page 19) of the “Basic Structure.”
Settings: Parallel, Ins AB, Ins BA
Rev Send (Reverb Send)
Determines the Send level of the signal sent from Insertion Effect A/B (or the bypassed signal) to the
Reverb effect. This is available only when “Part Output” is set to “MainL&R.”
Settings: 0 – 127
Var Send (Variation Send)
Determines the Send level of the signal sent from Insertion Effect A/B (or the bypassed signal) to the
Variation effect. This is available only when “Part Output” is set to “MainL&R.”
Settings: 0 – 127
Part Output (Part Output Select)
Determines the specific audio output.
Settings: MainL&R, AsgnL&R, USB1&2…USB29&30, AsgnL, AsgnR, USB1 – 30, Off
MainL&R: Outputs in stereo (two channels) to the OUTPUT [L/MONO]/[R] jacks.
AsgnL&R: Outputs in stereo (two channels) to the ASSIGNABLE OUTPUT [L]/[R] jacks.
USB1&2…USB29&30: Outputs in stereo (Channels 1&2 – 29&30) to the [USB TO HOST] terminal.
AsgnL: Outputs in mono (one channel) to the ASSIGNABLE OUTPUT [L] jack.
AsgnR: Outputs in mono (one channel) to the ASSIGNABLE OUTPUT [R] jack.
USB1 – 30: Outputs in mono (Channels 1 – 30) to the [USB TO HOST] terminal.
Off: No audio signal for the Part is output.
Envelope Follower
Calls up the Envelope Follower setting display. For details on the Envelope Follower, see the “Envelope
Follower Block” (page 20) in the “Basic Structure.”
Part (Input Source)
Displays the Part as “Input Source” for the selected Envelope Follower.
Settings: Master, AD, Part 1 – Part 16
Gain (Envelope Follower Gain)
Determines the Input gain of the Input Source set in “Part.”
Settings: -24dB – 0dB – +24dB
Attack (Envelope Follower Attack)
Determines the attack time of the Envelope Follower.
Settings: 1ms – 40ms