User Manual

Edit Search Utility Live SetPerformance
Normal Part (AWM2) Drum Part Normal Part (FM-X) Common/Audio
MONTAGE Reference Manual
Normal Part (AWM2) Edit
Common
Part Settings
General
Pitch
Zone Settings
Zone Transmit
Effect
Routing
Ins A
Ins B
EQ
Arpeggio
Common
Individual
Advanced
Motion Seq
Common
Lane
Mod / Control
Part LFO
Control Assign
Receive SW
Element
Osc / Tune
Pitch EG
Filter
Type
Filter EG
Scale
Amplitude
Level / Pan
Amp EG
Scale
Element LFO
Element EQ
All Element
Osc
Balance
73
Reference
EQ 1 Q (2-band EQ1 Q)/EQ 2 Q (2-band EQ2 Q)
Determines the EQ bandwidth for the frequency which is set in “EQ 1 Freq/EQ2 Freq.” This is available
only when “EQ Type” is set to “Peak/Dip.”
Settings: 0.1 – 12.0
NOTE For details on EQ structure, see the Synthesizer Parameter Manual PDF document.
Output Level (2-band Output Level)
Determines the Output level of the 2-band EQ.
Settings: -12dB – +12dB
From the Common display you can set Arpeggio-related parameters for the Part.
Arp Part (Part Arpeggio Switch)
Determines whether the Arpeggio for the selected Part is active or not.
Settings: Off, On
Arp Master (Arpeggio Master Switch)
Determines whether the Arpeggio for the entire Performance is active or not.
Settings: Off, On
Sync Quantize (Sync Quantize Value)
Determines the actual timing at which the next Arpeggio playback starts when you trigger it while the
Arpeggios for Parts are being played back. When set to “off,” the next Arpeggio starts as soon as you
trigger it. The number shown at right of each value indicates the resolution in clocks.
Settings: Off, 60 (32nd note), 80 (16th note triplet), 120 (16th note), 160 (8th note triplet), 240 (8th note), 320 (1/4 note triplet),
480 (1/4 note)
Arpeggio
Common
Operation
[PERFORMANCE]  [EDIT]  Part selection  ELEMENT/OPERATOR [COMMON]  [Arpeggio]
 [Common]