User Manual

Edit Search Utility Live SetPerformance
Normal Part (AWM2) Drum Part Normal Part (FM-X) Common/Audio
MONTAGE Reference Manual
Normal Part (AWM2) Edit
Common
Part Settings
General
Pitch
Zone Settings
Zone Transmit
Effect
Routing
Ins A
Ins B
EQ
Arpeggio
Common
Individual
Advanced
Motion Seq
Common
Lane
Mod / Control
Part LFO
Control Assign
Receive SW
Element
Osc / Tune
Pitch EG
Filter
Type
Filter EG
Scale
Amplitude
Level / Pan
Amp EG
Scale
Element LFO
Element EQ
All Element
Osc
Balance
77
Reference
From the Advanced display you can set advanced parameters related to the Arpeggio function.
Arp Part (Part Arpeggio Switch)
Arp Master (Arpeggio Master Switch)
Sync Quantize (Sync Quantize Value)
Same as in the Common display.
Accent Vel Threshold (Accent Velocity Threshold)
Determines the minimum velocity that will trigger the Accent Phrase.
Accent Phrases are composed of sequence data included in some Arpeggio types, sounding only when
you play notes at a velocity higher (stronger) than that specified in the Accent Velocity Threshold
parameter. If it is difficult to play at velocities necessary to trigger the Accent Phrase, set the “Accent Vel
Threshold” (Accent Velocity Threshold) parameter to a lower value.
NOTE For information on Arpeggio types that use this function, refer to the Data List PDF document.
Settings:
off, 1 – 127
Accent Start Quantize
Determines the start timing of the Accent Phrase when the Velocity specified in Accent Velocity Threshold
above is received. When this is set to off, the Accent Phrase starts as soon as the Velocity is received.
When this is set to on, the Accent Phrase starts on the beat specified for each Arpeggio type after the
Velocity is received.
Settings: off, on
Random SFX
Determines whether Random SFX is active or not.
Some Arpeggio types feature a Random SFX function which will trigger special sounds (such as guitar fret
noises) when the note is released.
NOTE For information on Arpeggio types that use this function, refer to the “Arpeggio Type List” in the Data List PDF
document.
Settings:
off, on
Random SFX Velocity Offset
Determines the offset value by which the Random SFX notes will be shifted from their original velocities.
Settings: -64 – +0 – +63
Advanced
Operation
[PERFORMANCE]  [EDIT]  Part selection  ELEMENT/OPERATOR [COMMON] [Arpeggio] 
[Advanced]