User Manual

Edit Search Utility Live SetPerformance
Normal Part (AWM2) Drum Part Normal Part (FM-X) Common/Audio
MONTAGE Reference Manual
Normal Part (AWM2) Edit
Common
Part Settings
General
Pitch
Zone Settings
Zone Transmit
Effect
Routing
Ins A
Ins B
EQ
Arpeggio
Common
Individual
Advanced
Motion Seq
Common
Lane
Mod / Control
Part LFO
Control Assign
Receive SW
Element
Osc / Tune
Pitch EG
Filter
Type
Filter EG
Scale
Amplitude
Level / Pan
Amp EG
Scale
Element LFO
Element EQ
All Element
Osc
Balance
81
Reference
From the Lane display you can set parameters for each Lane of the Motion Sequencer.
Motion Seq Master SW (Motion Sequencer Master Switch)
Determines whether the Motion Sequencer for the entire Performance is active or not.
Settings: Off, On
Motion Seq Part SW (Motion Sequencer Part Switch)
Determines whether the Motion Sequencer for the selected Part is active or not.
Settings: Off, On
Lane SW (Lane Switch)
Determines whether each Lane is active or not. Up to four Lanes of Motion Sequencer can be used for one
Part and up to eight Lanes can be used at the same time for the entire Performance. When this is set to off,
parameters related to the corresponding Lane will not be displayed.
Settings: Off, On
MS FX (Lane Motion Sequencer FX Receive)
Determines whether or not the selected Lane is affected by Knob operations when the corresponding
Knob Function [ARP/MS FX] button is set to on.
Settings: Off, On
Trigger (Lane Motion Sequencer Trigger Receive)
Determines whether or not the selected Lane receives the signal generated by [MOTION SEQ TRIGGER]
button. When this is set to on, the Motion Sequence will begin whenever you press the [MOTION SEQ
TRIGGER] button.
Settings: Off, On
Sequence Select (Lane Motion Sequence Select)
Selects the desired Motion Sequence.
Settings: 1 – 8
Lane
Operation
[PERFORMANCE]  [EDIT]  Part selection  ELEMENT/OPERATOR [COMMON]  [Motion Seq]
 [Lane]