User Manual

ManualsBrandsYamaha ManualsSynthesizersMOTIF XF Series

131

132

133

134

135

136

137

138

139

140

Creating a Voice/Performance by Using the Sampling Function

MOTIF XF Reference Manual

131

Voice mode

Song mode

Pattern mode

Mixing mode

Master mode

Utility mode

File mode

Performance

mode

Sampling

mode 1

Sampling

mode 2

Reference

1 Source Key Bank

2 Destination Key Bank

The source Key Bank is set by using the [SF5] Keybank

button or [SF6] KBD button to select the key in the

waveform after selecting the Waveform number (001 –

128). The source Key Bank is set by moving the cursor to

the Key value and using the Data dial or [SF6] KBD button

to select the desired key after selecting the Waveform

number (001 – 128). The Velocity range values of the

destination Key Bank are automatically set to the same as

those of the source Key Bank.

n You can hear the sample assigned to the source Key Bank by

pressing the [SF1] Audition button.

This Job deletes the specified Key Bank and its Sample.

By deleting unnecessary Samples, you can increase the

available memory space.

1 Key Bank to be deleted

Determines the Key Bank to be deleted by setting the

Waveform number (001 – 128). The Key range and Velocity

range of the Key Bank to which the selected Waveform is

assigned are automatically shown below the Waveform

number.

This Job moves a specified Key Bank to another

Waveform. Also the Sample assigned to the Key Bank is

moved.

1 Source Key Bank

2 Destination Key Bank

Determines the Key Banks of source and destination

respectively by setting the Waveform number (001 – 128).

Setting the source Waveform number calls up one of the

Key Banks (the Key range and Velocity range) which can

be changed by pressing the [SF5] Keybank button and

[SF6] KBD button. The Key range and Velocity range of the

destination Key Bank are automatically set to the same

values as those of the source Key Bank.

n You can hear the sample assigned to the source Key Bank by

pressing the [SF1] Audition button.

This Job maximizes (normalizes) the overall level of the

specified Sample. This is useful for bringing up the volume

of a Sample that was inadvertently recorded at a low level.

1 Key Bank

Determines the Key Bank to which the desired Sample is

assigned by specifying the Waveform number (001 – 128).

The Key range and Velocity range of the Key Bank to which

the selected Waveform is assigned are automatically

shown below the Waveform number.

2 Ratio

Determines the post-normalization Sample level. A setting

of 100% maximizes the level so that the highest peak level

in the Sample is just below clipping (maximum digital

signal level). Settings higher than 100% will raise the

Sample level above the maximum, producing deliberate

clipping. Normally, set this to 100% or less.

Settings: 1% – 800%

02: Delete

03: Move

04: Normalize