User Manual

Creating a Voice/Performance by Using the Sampling Function
MOTIF XF Reference Manual
135
Voice mode
Song mode
Pattern mode
Mixing mode
Master mode
Utility mode
File mode
Performance
mode
Sampling
mode 1
Sampling
mode 2
Reference
1 Waveform as source
2 Waveform as destination
Determines the copy source and destination Waveform
numbers.
NOTICE
This operation overwrites any data previously existing at the
destination Waveform number.
This Job lets you delete a specific Waveform from memory.
The Key Banks and Samples included in the Waveform are
also deleted.
Waveform
Determines the Waveform number to be deleted.
This Job lets you delete all unnecessary parts of the
Sample (located ahead of the Start Point and located after
the End Point).
Waveform
Determines the Waveform number to be extracted.
This Job lets you transpose the Key Bank setting of a
specified Waveform in semitones or in octaves.
1 Waveform
Determines the Waveform number to which this Job is
applied.
2 Octave
Determines the amount in octaves by which the Key Bank is
transposed. When you want to transpose by less than one
octave, set this to “0” and use the Note parameter below.
Settings: -3 – +0 – +3
3 Note
Determines the amount in semitones by which the Key Bank is
transposed. When you want to transpose by exact octaves,
set this to “0” and use the Octave parameter above.
Settings: -11 – +0 – +11
This Job lets you assign a name to the selected Waveform.
1 Waveform
Determines the Waveform number to which this Job is
applied.
2 Name
Determines the Waveform name which can contain up to
10 characters. For detailed instructions on naming, refer to
“Basic Operation” on page 37.
[F3] Other Jobs
This Job optimizes the memory (SDRAM) for Sampling.
Optimization consolidates areas of used and unused
(available) memory to create the largest possible area of
contiguous available memory. In some cases, the amount
of remaining memory will be increased when you execute
the Optimize Memory Job.
This Job deletes all the user Waveforms. The Key Banks
and Samples included in the Waveform are also deleted.
This Job copies the Sample data on SDRAM to the optional
Flash Memory Expansion Module (FL512M/FL1024M) as
Waveforms.
02: Delete
03: Extract
04: Transpose
Start point End point
Extract
Start point End point
1
2
3
05: Rename
01: Optimize Memory
02: Delete All
03: Copy to Flash Memory
1
2