User Manual

Editing a Drum Voice
MOTIF XF Reference Manual
86
Voice mode Song mode Pattern mode Mixing mode Master mode Utility mode File mode
Performance
mode
Sampling
mode 1
Sampling
mode 2
Reference
Controller settings—[F4] Ctrl Set
(Controller Set)
This is the same as in Normal Voice Common Edit. See
page 61. Please note that the Element Switch parameter is
not available in Drum Voice Common edit.
Effect settings—[F6] Effect
This display gives you comprehensive control over the
effects. The functions on this display are basically same as
in Normal Voice Common Edit (page 64). The different
point is that the Insertion Effect Out parameter is set not for
each Element but for each Drum Key. In addition to that,
three more parameters ($ – ^) are available.
1 Out (Insertion Effect Out)
Determines which Insertion Effect (A or B) is used to
process each individual Drum Key. Parameters can be set
for each Drum Key. When INSERTION CONNECT (2) is set
to “ins L,” the signal from each Drum Key is output to the
Insertion L regardless of the setting here.
Settings: thru (through), Ins A (Insertion A), Ins B (Insertion B)
Parameters 2 – # are same as the ones on the Connect
display (page 64) in the Normal Voice Edit mode.
$ Key
Determines the Drum Key to be edited. The Insertion Effect
Out (1), Key Reverb Send (%) and Key Chorus Send (^)
can be set for each Drum Key.
Settings: C0 – C6
% REV SEND (Key Reverb Send)
Determines the level of the Drum key sound (the bypassed
signal) that is sent to Reverb effect. The setting here is
available only when the Insertion Effect Out parameter (1)
is set to “thru.”
Settings: 0 – 127
n When the Insertion Effect Out parameter (1) is set to “Ins A” or
“Ins B,” you can determine the level of the Drum Key sound
(output from Insertion Effect A or B) that is sent to the Reverb
effect by setting the value of the Insertion Reverb Send
parameter indicated only in this case.
^ CHO SEND (Key Chorus Send)
Determines the level of the Drum key sound (the bypassed
signal) that is sent to Chorus effect. The setting here is
available only when the Insertion Effect Out parameter (1)
is set to “thru.”
Settings: 0 – 127
n When the Insertion Effect Out parameter (1) is set to “Ins A” or
“Ins B,” you can determine the level of the Drum Key sound
(output from Insertion Effect A or B) that is sent to the Chorus
effect by setting the value of the Insertion Chorus Send
parameter indicated only in this case.
This is the same as in Normal Voice Common Edit. See
page 66.
Effect Connection Settings—[SF1]
Connect
3
4
5
2
6
^
7
1
%
$
8
9
)
!
#
@
Effect Parameter settings—[SF2] Ins A
– [SF5] Chorus