User Manual

Troubleshooting

MOXF6/MOXF8 Remote Editor Owner’s Manual

On the DAW software other than Cubase, the set parameters are not controlled.

• The Remote control functions are available only for Cubase. Set the Remote/CC buttons (page 7) to

“CC.”

• Make sure to select a parameter except to “Cubase” on the Daw Select display of the Utility mode in

the MOXF6/MOXF8 instrument.

Even when I select another track on the DAW software, the VSTi to be controlled does

not change; instead, the VSTi which is assigned to the previously selected track

remains under control.

• When using Cubase, select [Editing]-[Project & Mixer] on the Preferences dialog, then checkmark

both “Sync Project and Mixer Selection” and “Enable Record on Selected Track.”

• When using Cubase, select “Yamaha MOXF6/MOXF8” in the Remote Device Setup window, then

select Port 2 for the MOXF6/MOXF8 as the MIDI Input/Output.

• Make sure to set the MOXF6/MOXF8 instrument to the Remote mode. (page 5)

C.S.G., Digital Musical Instruments Division

308MW-A0