User Manual

MOXF6/MOXF8 Editor Window: Bottom section
MOXF6/MOXF8 Editor Owner’s Manual
31
Bottom section
1 Controller Set status
This section indicates which controller on the MOXF6/MOXF8 instrument is used as the Control Source
of the Controller Set.
1 Part
Indicates the current Part.
2 Control Source (Controller)
Indicates the six controllers as source of the Controller Set. The abbreviations for the Controllers are as
follows:
3 On/Off status
When a lamp is turned on, a certain function (Destination) is assigned to the corresponding Source
(controller). When a lamp is turned off, no function (Destination) is assigned to the corresponding Source
(controller).
2 Quick Setup, USB I/O Mode, Direct Monitor, Local Ctrl
On the MOXF6/MOXF8, up to 6 parameter settings for the computer connection can be stored as Quick
Setups. The stored Quick Setups can be recalled from the Quick Setup section of this Editor as well as
via the [QUICK SETUP] button of the MOXF6/MOXF8.
n This Editor cannot edit or store each setup.
From among the parameters included in Quick Setup, you can confirm the status of “USB I/O Mode”,
“Direct Monitor” and “Local Ctrl” with the indicators. By clicking these indicators, you can also edit these
parameters.
Indication Control Source Indication Control Source
PB Pitch Bend Wheel BC Breath Controller
MW Modulation Wheel AS1 ASSIGN 1 knob
AT After Touch (keyboard) AS2 ASSIGN 2 knob
FC Foot Controller FC2 Foot Controller 2
FS Foot Switch AF1 ASSIGNABLE FUNCTION 1 button
RB Ribbon Controller AF2 ASSIGNABLE FUNCTION 2 button
1
2
5
7
6
34
8
1
3
2