User Manual

An Example of MOXF6/MOXF8 Editor in Use: Editing in the Voice mode

MOXF6/MOXF8 Editor Owner’s Manual

An Example of MOXF6/MOXF8 Editor in Use

There is no single way to use the many components in the MOXF6/MOXF8 Editor. Your editing needs and

preferences may differ; however, the following example gives you a simple step-by-step guide in how to use

the MOXF6/MOXF8 Editor. As an example, this section explains how to edit a Voice in the Voice mode, edit a

Mixing program in the Song mode, then store the edited data to the memory of the MOXF6/MOXF8

instrument and save the final results of your editing to a file.

Editing in the Voice mode

n If the [Song] or [Pattern] indication (at the top left of the display) is on, perform the instructions below from step 1. If the

[Voice] indication is on, perform the instructions below from step 2.

1. Change the mode to the Voice mode by clicking the [Voice] indication (at the top left of

the display).

If the [ONLINE]/[OFFLINE] indication is set to [ONLINE] before changing the mode, the Auto Sync

window will be called up automatically when this step is executed. As step 2 is thus unnecessary, you

should proceed to step 3.

2. Click the [OFFLINE] to call up the Auto Sync window if the [ONLINE]/[OFFLINE]

indication is set to [OFFLINE].

3. On the Auto Sync window, set communication-related parameters such as Input Port,

Output Port and Device Number in the Data Port section, then set the direction of Data

Auto Synchronization (Global, Current and Voice) in the Auto Sync Setting section.

When you want to use the settings on the MOXF6/MOXF8 itself as starting data for editing, set the boxes

of Global, Current and Voice in the Auto Sync Setting to on so that the data flows from the instrument to

the computer. To use the settings on the MOXF6/MOXF8 Editor as starting data, set both Global, Current

and Voice to the opposite, so that the arrow indicates data flow from the computer to the keyboard. For

details, see page 37.

NOTICE

• Keep in mind that when you set Global, Current and Voice to On, enable data sync from the computer to the

MOXF6/MOXF8 (instrument), and then click the [Start] button at the bottom, this operation transmits these types of

data currently on the Editor to the MOXF6/MOXF8 itself, automatically overwriting and erasing all the

corresponding data already existing on memory of the MOXF6/MOXF8 instrument. When you want to use the

settings on the MOXF6/MOXF8 itself as starting data for editing, set the boxes of Global, Current and Voice in the

Auto Sync Setting to on so that the data flows from the instrument to the computer.

• Make sure to set the desired data transfer direction in order to avoid data loss.

• Any data which was overwritten and lost accidentally cannot be recovered.