User Manual

PERF SONG PATTERN MIX MASTER REMOTE UTILITY QUICK SET FILEVOICE
MOXF6/MOXF8 Reference Manual
Voice Mode
Voice Play
[F1] PLAY
[F3] PORTA
[F4] EG
[F5] ARP ED
[F6] EFFECT
Arpeggio Edit
[F2] TYPE
[F3] MAIN
[F4] LIMIT
[F5] PLAY FX
Normal Voice Edit
Common Edit
[F1] GENERAL
[F2] OUTPUT
[F3] EQ
[F4] CTL SET
[F5] LFO
[F6] EFFECT
Element Edit
[F1] OSC
[F2] PITCH
[F3] FILTER
[F4] AMP
[F5] LFO
[F6] EQ
Drum Voice Edit
Common Edit
[F1] GENERAL
[F2] OUTPUT
[F3] EQ
[F4] CTL SET
[F6] EFFECT
Key Edit
[F1] OSC
[F2] PITCH
[F3] FILTER
[F4] AMP
[F6] EQ
Voice Job
[F1] INIT
[F2] RECALL
[F3] COPY
[F4] BULK
Supplementary Information
46
KeyOnReset
Determines whether or not the LFO is reset each time a note is played.
Settings: off, on
KeyOnDelay
Determines the delay time between the moment that a Note On message is received and the moment the LFO comes
into effect.
Settings: 0 – 127
PMod (Pitch Modulation Depth)
Determines the amount (depth) by which the LFO waveform varies (modulates) the pitch of the sound.
Settings: 0 – 127
FMod (Filter Modulation Depth)
Determines the amount (depth) by which the LFO waveform varies (modulates) the Filter Cutoff frequency.
Settings: 0 – 127
AMod (Amplitude Modulation Depth)
Determines the amount (depth) by which the LFO waveform varies (modulates) the amplitude or volume of the sound.
Settings: 0 – 127
FadeInTime
Determines the amount of time for the LFO effect to fade in (after the “KeyOnDelay” time has elapsed).
Settings: 0 – 127
Type
Determines the Equalizer Type.
Settings: 2 Band, P.EQ (Parametric EQ), Boost6 (boost 6dB), Boost12 (boost 12dB), Boost18 (boost 18dB), thru
2 Band.....................................This is a “shelving” equalizer, which combines separate high and low frequency bands.
P.EQ (Parametric EQ) .............. The Parametric EQ is used to attenuate or boost signal levels (gain) around the Frequency. This
type features 32 different “Q” settings, which determine the frequency band width of the
equalizer.
Boost6 (boost 6dB)/Boost12 (boost 12dB)/Boost18 (boost 18dB)
................................................. These can be used to boost the level of the entire signal by 6dB, 12dB and 18dB, respectively.
thru .......................................... This setting bypasses the equalizers leaving the entire signal unaffected.
[F6] EQ (Equalizer)
Off On
Key on Key on
Time Time
–
+
0
–
+
0
When set to 2 Band When set to P.EQ
Gain
Gain
Low Freq
Settings: 50.1Hz – 2.00kHz
High Freq
Settings: 503.8Hz – 10.1kHz
Frequency
High Gain
Settings: -32 – +0 – +32
Low Gain
Settings: -32 – +0 – +32
Freq
Settings: 139.7Hz – 12.9kHz
Gain
Settings: -32 – +0 – +32
Frequency
Q
Settings: 0 – 31