User Manual

MOXF6/MOXF8 Editor Installation Guide 4
To use the MOXF6/MOXF8 Editor VST as a VST3 plug-in of the Cubase series, you’ll need to install the following
software programs. Follow the appropriate instructions below corresponding to the software you’re using.
• Yamaha Steinberg USB Driver
• MOXF6/MOXF8 Editor VST
Driver Installation
To operate your Yamaha hardware from your computer via a USB cable, you’ll need to install the Yamaha Steinberg
USB Driver.
The Yamaha Steinberg USB Driver is necessary when transferring Audio/MIDI data back and forth between your
computer’s Cubase series and the MOXF6/MOXF8.
n MOXF6/MOXF8 Editor VST cannot be used over a MIDI connection.
n The MOXF6/MOXF8 Editor VST will transmit/receive the related messages as MIDI messages to/from the MOXF6/MOXF8 only when the
computer to which Yamaha Steinberg USB driver has been installed is connected directly to the MOXF6/MOXF8 via USB. Note that the
different connection manner (via MIDI cables, etc.) disables the communication of the Editor related messages. Even if such a
connection is executed, make sure to connect the MOXF6/MOXF8 directly to the computer via USB.
Software Installation
Make sure to check the following website for installation and up-to-date news on the Yamaha Steinberg USB Driver.
http://download.yamaha.com/
Cubase
series
USB cable
Driver
Computer MOXF6/MOXF8