User Manual

MOXF6/MOXF8 Owner’s Manual
Appendix
72
4-2 Press the top of the connector as shown, then push the
connector firmly into the slot.
4-3 Tighten each screw of the Memory Module to each
female screw of the MOXF with your hand as shown
below.
5 Re-install the cover you removed in step 3, in
reverse order.
6 Check that the installed Module or Modules are
functioning properly.
6-1 Turn the MOXF right side up again so that the keyboard
faces up then turn the power on. While launching, you
will see a message indicating that the Flash Memory
Module cannot be recognized.
6-2 Press the [FILE] button to enter the File mode then
press the [F6] FLASH button.
6-3 Press the [SF1] Format button.
6-4 Press the [ENTER] button to execute the Format
operation.
6-5 Check whether the Total size shown on the display is
correct or not.
Removing the Module
1 Loosen both the screws.
NOTICE
• If you cannot loosen the screw with your hand, use a Phillips
screwdriver. In this case, be careful NOT to scratch the circuit
board of the FL512M/FL1024M and MOXF.
• Since the screws can be removed from the module, be careful NOT
to drop them inside the instrument when loosening them.
2 Pull out the FL512M/FL1024M vertically.
3 Attach the cover to the bottom panel.
Position the cover on the bottom panel aligning the screws
with the screw holes, then tighten the screws with a Phillips
screwdriver to fix the cover.
Press this section
lightly but firmly
Serial No. seal
 Rear side
Bottom