User Manual
Table Of Contents
- Cover
- Introduction
- Setup workflow
- Example 1) Ballroom where the Room Combiner can be used
- Example 2) Remote conferencing system that also uses Speech Privacy
- Using the Device Configuration Wizard to create your device setup
- Configuring the settings on the MRX
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the MRX
- Powering-on the amp
- Specifying the computer’s TCP/IP address
- Sending the Speech Privacy environmental sound
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Example 3) A paging system using the PGM1
- Using the Device Configuration Wizard to create your device setup
- Specifying the MRX configuration
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the PoE-equipped gigabit network switch
- Specifying the MCP1’s UNIT ID
- Power-on equipment other than amps and powered speakers
- Power-on amps and powered speakers
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Q&A
- Uninstalling the software (Removing the application)
Example 1) Ballroom where the Room Combiner can be used
MRX Setup Manual
13
Configuring the settings on the MRX
Use the MRX Designer to set an internal configuration on the MRX.
When you have finished each setting, we recommend that you save the configuration from the [File] menu → [Save].
Starting the MRX Designer
Click the tab for the system name that you set in step 1 of “Using the Device Configuration Wizard to create your
device setup” to go to the settings screen.
After going to the settings screen, click the “Open MRX Designer” button to start the MRX Designer.
Placing and connecting the components related to the mics in Room A
Here we will place and connect the components related to the mics in Room A.
1.
Place the components shown below by dragging them from the “Components” area
and dropping them into the Design sheet.
• “ANALOG IN”
• “HPF” (MONO)
• “PEQ” (MONO, 4 BAND)
• “Compressor” (MONO)
• “Notch FBS”(Feedback Suppressor)
• “Auto Gain Control” (MONO)
• “Fader” (4 CH)
Placing and connecting the components
NOTE
The “User Account Control” dialog box may display. Click either [Continue] or [Yes].