User Manual
Table Of Contents
- Cover
- Introduction
- Setup workflow
- Example 1) Ballroom where the Room Combiner can be used
- Example 2) Remote conferencing system that also uses Speech Privacy
- Using the Device Configuration Wizard to create your device setup
- Configuring the settings on the MRX
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the MRX
- Powering-on the amp
- Specifying the computer’s TCP/IP address
- Sending the Speech Privacy environmental sound
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Example 3) A paging system using the PGM1
- Using the Device Configuration Wizard to create your device setup
- Specifying the MRX configuration
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the PoE-equipped gigabit network switch
- Specifying the MCP1’s UNIT ID
- Power-on equipment other than amps and powered speakers
- Power-on amps and powered speakers
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Q&A
- Uninstalling the software (Removing the application)
Example 1) Ballroom where the Room Combiner can be used
MRX Setup Manual
38
In this example, we’ll see how we can avoid the unnecessary use of DCP switches and knobs, such as by assigning a single
fader to a stereo pair of inputs (such as a Blu-Ray player or AUX In), or by making a single ON button for both L and R.
Here we’ll create a parameter link group that links multiple parameters such as levels or ON/OFF, so that we can change
multiple parameters at the same time with a DCP knob or button.
As with snapshots, parameter link groups are registered by dragging and dropping while holding down <Ctrl>. However, in
this example we will use a different method, since there are a total of 24 parameters to change. The same operation can be
used with snapshots.
1.
Open the “Parameter Link Group” area on the left side of the MRX Designer, in order to
check the parameters that are registered.
Setting a parameter link group