User Manual
Table Of Contents
- Cover
- Introduction
- Setup workflow
- Example 1) Ballroom where the Room Combiner can be used
- Example 2) Remote conferencing system that also uses Speech Privacy
- Using the Device Configuration Wizard to create your device setup
- Configuring the settings on the MRX
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the MRX
- Powering-on the amp
- Specifying the computer’s TCP/IP address
- Sending the Speech Privacy environmental sound
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Example 3) A paging system using the PGM1
- Using the Device Configuration Wizard to create your device setup
- Specifying the MRX configuration
- Making EXT. I/O settings
- Connecting the equipment
- Powering-on the PoE-equipped gigabit network switch
- Specifying the MCP1’s UNIT ID
- Power-on equipment other than amps and powered speakers
- Power-on amps and powered speakers
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Verifying that the settings were applied
- Q&A
- Uninstalling the software (Removing the application)
Example 2) Remote conferencing system that also uses Speech Privacy
MRX Setup Manual
70
9.
When you see the dialog box “Display the configuration diagram? The diagram can also
be printed.” click [Yes].
A cabling diagram will appear. If you want, click [Print] to print the diagram.
To close the screen, click [Close].
If you want to use the Device Configuration Wizard to change the device configuration, click the [Device Config] but-
ton in the Project screen.
NOTE
If you want to view the cabling diagram again, do so by choosing [File] menu → [Print Configuration Diagram].