User Manual
Table Of Contents
- Cover
- Introduction
- Setup workflow
- Example 1) Basic MTX3 system example (analog connections)
- Example 2) High audio quality system with XMV and YDIF connections (digital connections)
- Example 3) Using cascade mode to add MTX input channels (analog connection)
- Using the Device Configuration Wizard to create your device setup
- Making preliminary settings in MTX-MRX Editor
- Connecting the equipment
- Powering-on the MTX
- Powering-on the amp
- Setting the MCP1’s UNIT ID
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Making XMV settings
- Verifying that the settings were applied
- Example 4) A system using Dante
- Using the Device Configuration Wizard to create your device setup
- Making preliminary settings in MTX-MRX Editor
- Dante settings between systems
- Connecting the equipment
- Powering-on the MTX
- Powering-on the amp
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Making XMV settings
- Verifying that the settings were applied
- Example 5) A system using the PGM1 for paging
- Using the Device Configuration Wizard to create your device setup
- Making preliminary settings in MTX-MRX Editor
- Connecting the equipment
- Power-on the PoE-equipped gigabit network switch
- Power-on equipment other than amps and powered speakers
- Power-on amps and powered speakers
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Making XMV settings
- Verifying that the settings were applied
- Q&A
- Uninstalling the software (Removing the application)
MTX Setup Manual 124
Place the “Paging” component, and assign broadcast destinations (zones, zone groups) or pre-recorded messages to the
zone/message select buttons of the PGM1.
You can use the buttons to select the broadcast destination (multiple selections are allowed) and play back pre-recorded
messages from the SD card.
Up to four PGM1 units can be connected to an MTX/MRX system that includes an MTX5-D. One PGM1 unit can control
one MTX5-D, and this PGM1 together with the MTX5-D are collectively called a Paging Device Group. One of the PGM1
units within the Paging Device Group is the 1
st
Priority Mic; this unit can broadcast taking priority over the other PGM1
units.
There are three ways to use the PGM1.
Broadcast from the mic.
1.
Use the zone/message select buttons to select the broadcast area.
2.
Press the PTT button.
If specified, the Opening Chime is heard.
3.
When the status indicator is lit red, speak into the mic.
4.
When you finish speaking, press the PTT button.
If specified, the Closing Chime is heard.
Example 5) A system using the PGM1 for paging
P
P
PGX1
ID=0
PGX1
ID=1
PGM1
ID=60
PGX1
ID=0
PGX1
ID=1
PGM1
ID=61
PGX1
ID=0
PGX1
ID=1
PGM1
ID=62
MRX7-D ID=01
MTX5-D ID=02
PGX1
ID=0
PGX1
ID=1
PGM1
ID=63
SWR2100P-10G
Paging Device Group 1
Paging Device Group 2
=Priority microphone