User Manual
Table Of Contents
- Cover
- Introduction
- Setup workflow
- Example 1) Basic MTX3 system example (analog connections)
- Example 2) High audio quality system with XMV and YDIF connections (digital connections)
- Example 3) Using cascade mode to add MTX input channels (analog connection)
- Using the Device Configuration Wizard to create your device setup
- Making preliminary settings in MTX-MRX Editor
- Connecting the equipment
- Powering-on the MTX
- Powering-on the amp
- Setting the MCP1’s UNIT ID
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Making XMV settings
- Verifying that the settings were applied
- Example 4) A system using Dante
- Using the Device Configuration Wizard to create your device setup
- Making preliminary settings in MTX-MRX Editor
- Dante settings between systems
- Connecting the equipment
- Powering-on the MTX
- Powering-on the amp
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Making XMV settings
- Verifying that the settings were applied
- Example 5) A system using the PGM1 for paging
- Using the Device Configuration Wizard to create your device setup
- Making preliminary settings in MTX-MRX Editor
- Connecting the equipment
- Power-on the PoE-equipped gigabit network switch
- Power-on equipment other than amps and powered speakers
- Power-on amps and powered speakers
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Making XMV settings
- Verifying that the settings were applied
- Q&A
- Uninstalling the software (Removing the application)
Introduction
MTX Setup Manual
3
Example 2) High audio quality system with XMV and YDIF connections (digital connections)
This repeats the system of example 1, replacing the amps with an XMV series unit.
This example assumes that you’re using the following equipment.
•MTX3 × 1
• DCP1V4S × 4
• XMV4280 (four channels of amplification) × 1
• Speakers (the number needed)
• SD memory card × 1
• Background music source such as a CD player × 1
• Network switch × 1
• Paging microphones with switch × 2
• Wireless microphone receivers (2 channels)
• Wireless microphones × 2
The number of speakers is not specified; choose amps that are suitable for your speaker setup. You will also need to
provide the appropriate number of cables.
XMV4280 ID
=1A
BGM Player
DCP
ID=3
Kitchen
(Zone 4)
Hall A
(Zone 1)
Hall B
(Zone 2)
Entrance
(Zone 3)
DCP
ID=1
Microphone
Ch=2
Microphone
Ch=1
Microphone
Ch=4
DCP
ID=0
Amp
Room
DCP
ID=2
Microphone
Ch=3
MTX3 ID=01
CD Player
Wireless Microphone Reciever