User Manual
Table Of Contents
- Cover
- Introduction
- Setup workflow
- Example 1) Basic MTX3 system example (analog connections)
- Example 2) High audio quality system with XMV and YDIF connections (digital connections)
- Example 3) Using cascade mode to add MTX input channels (analog connection)
- Using the Device Configuration Wizard to create your device setup
- Making preliminary settings in MTX-MRX Editor
- Connecting the equipment
- Powering-on the MTX
- Powering-on the amp
- Setting the MCP1’s UNIT ID
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Making XMV settings
- Verifying that the settings were applied
- Example 4) A system using Dante
- Using the Device Configuration Wizard to create your device setup
- Making preliminary settings in MTX-MRX Editor
- Dante settings between systems
- Connecting the equipment
- Powering-on the MTX
- Powering-on the amp
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Making XMV settings
- Verifying that the settings were applied
- Example 5) A system using the PGM1 for paging
- Using the Device Configuration Wizard to create your device setup
- Making preliminary settings in MTX-MRX Editor
- Connecting the equipment
- Power-on the PoE-equipped gigabit network switch
- Power-on equipment other than amps and powered speakers
- Power-on amps and powered speakers
- Specifying the computer’s TCP/IP address
- Taking MTX-MRX Editor online
- Making XMV settings
- Verifying that the settings were applied
- Q&A
- Uninstalling the software (Removing the application)
Example 4) A system using Dante
MTX Setup Manual
94
We’ll start by making settings for System A.
Making EXT. I/O settings
Make settings for inputting and outputting digital audio. First we will make YDIF settings for System A. Click the
SYSTEM tab to access the setting screen.
1.
Click the [EXT. I/O] button.
The “EXT. I/O” screen will appear, allowing you to make input/output settings for the external devices. Since
you’ll be making settings for YDIF 1–8, there’s no need to switch screens; simply make the settings in this screen.
2.
Click the [EDIT] button.
Here you can specify YDIF 1–8 input/output settings for the EXi8 and EXo8.
3.
Click the EXi8’s input routing select button for YDIF 1.
The “YDIF In Patch” dialog box will appear.
Input routing
select buttons
[EDIT] button