User Manual

Example 4) Dividing between two meeting rooms and conferencing with separate locations
MTX5-D/MY4-AEC System Setup Manual
23
 Examples of adjusting the settings
• Adjusting the volume of the audio signal from the remote location
For meeting room ‘A’, operate the fader of input channel 9. For meeting room ‘B’, operate the fader of input channel
10. While you watch the level meter, adjust the input level so that the yellow indicator lights occasionally.
• Adjusting the volume of a microphone of the local location
For meeting room ‘A’, operate the faders of input channels 17 through 20. For meeting room ‘B’, operate the faders of
input channels 21 through 24. While you watch the level meter, adjust the input level so that the yellow indicator
lights occasionally.
• Adjusting the volume of the speaker of the local location
Adjust the input level as described in “Adjusting the volume of the audio signal from the remote location” and
“Adjusting the volume of a microphone of the local location,” above.
• If you don’t want the audio from the local microphone to be output from the speaker
For meeting room ‘A’, turn off the sends of input channels 2 and 4 in the “MATRIX” screen. For meeting room ‘B’,
turn off the sends of input channels 6 and 8 in the “MATRIX” screen.
• If you want to connect recording/playback device
For recording, connect your device to the MTX5-D’s “OUTPUT” 2 connector and 5 connector (2 is meeting room
‘A’, and 5 is meeting room ‘B’). For playback, connect your device to the MTX5-D’s “ST IN” 2L/2R connectors (2L
is meeting room ‘A’, and 2R is meeting room ‘B’). When you record, turn on the [ON] button of input channels
STIN2L/STIN2R. When playing back, turn on the [ON] button of output channels OUT3/OUT7.
NOTE
Feedback may occur if you have connected a type of recording/playback device that outputs the input signal while recording is
paused. If feedback occurs, click the [ON] button of input channel STIN2L/STIN2R to turn it off. When playing back, turn this button
back on.