User Manual
Table Of Contents
- Cover
- Introduction
- Example 1) One remote location, and four microphones in the meeting room
- Example 2) One remote location, and eight microphones in the meeting room
- Example 3) Four remote locations, and four mics in the meeting room
- Example 4) Dividing between two meeting rooms and conferencing with separate locations
- Appendix
Introduction
MTX5-D/MY4-AEC System Setup Manual
3
Example 1) One remote location, and four microphones in the meeting room
This is an example of one remote location with four or fewer local microphones.
Use the AEC 4Mic 1RemoteLocation-*.mtx file.
This example assumes that you’re using the following equipment.
•MTX5-D 1
•MY4-AEC 1
• XMV4140 (Amplifier) 1
• Microphones (Boundary microphones) 4
• Speakers (the number needed)
• CODEC or other devices needed for communicating with the remote location 1
• Communication network with the remote location 1
The number of speakers is not specified; choose amplifiers that are suitable for your speaker setup. You will also need to
provide the appropriate number of cables.
For details on this example, refer to page 7 and following.
Microphone 1
Microphone 2
Microphone 3
Microphone 4
Network
Analog IN/OUT
YDIF
Analog IN
Analog OUT
MTX5-D
XMV4140
CODEC Remote A
Meeting room