User Manual

Menu bar
Yamaha LAN Monitor User Guide

4 Keepalive
This pings slaves and devices with an IP address to confirm their existence. This is used to set the ping
interval, the wait time for reply, and the number of failed attempts before a connection is assumed to be down.
 
Set the ping interval in seconds.
 1 – 1800 sec
 10 sec
 
Set the wait time for reply to pings in seconds.
 1 – 60 sec
 1 sec
 
Set the number of failures before a connection is detected as being down.
 1 – 100 times
 3 times
5 Power supply interruption time
Suspends the power supply when a disrupted or inactive connection is detected. Set the power supply
interruption time in seconds in case of interruption.
 1 – 60 sec
 5 sec
6 
Select the size of the preview image of the "Whole map" generated for print preview and printing.
If printing or previewing the "Whole map" has failed, the failure may be avoided by setting the preview size to
A6.
7 Snapshot function
 
Clear this check box to exclude devices as targets for comparisons.
 Selected
8 [OK] button
Applies the configured settings.
NOTE
• The [OK] button is only available when acceptable input values have been input.
• Click the [OK] button to reset the monitoring timer and begin counting from 0 seconds again.
9 [Cancel] button
Closes the dialog box without applying setting changes.