User Manual
Table Of Contents
- Information
- About Yamaha LAN Monitor
- Contents
- Terminology
- Steps to use the software
- Software operating requirements
- Notes
- Notes regarding device detection
- Notes regarding Yamaha PoE switch detection
- Notes regarding the power supply interruption function for the Yamaha PoE switch
- Notes regarding a slave whose stack function is enabled
- Notes on printing and print preview of the "Whole map"
- Notes regarding detection of Dante-enabled devices
- Notes regarding when using macOS10.15.x
- Installing and uninstalling Yamaha LAN Monitor
- Starting and exiting Yamaha LAN Monitor
- Yamaha LAN Monitor screen structure
- Network settings on the computer
- Basic operation
- Menu bar
- Toolbar and display area
- Main screen
- Web GUI
- Resources
- Troubleshooting
Toolbar and display area
Yamaha LAN Monitor User Guide
1 Ping
You can ping one or more specified IP addresses. Select a radio button to specify which type of test you
want to execute.
Click the [Execute] button to start a ping test. The results of the ping test appear in the Result of searching area.
When you select [IP address] and execute a ping test, the Result of searching area displays the test results
regardless of whether there is a reply.
When you select [IP address range] and execute a ping test, the Result of searching area lists only the IP
addresses that replied.
Select this to ping a single IP address.
Select this to ping a specified range of IP addresses.
: Enter the starting IP address.
: Enter the ending IP address.
Shows the number of IP addresses in the specified range.
During a ping test, this shows the number of sent ping messages and the rate of progression.
Click the [Execute] button to start a ping test.
During the ping test, this button switches to [Stop]. You can click this button to terminate the ping test.
2 Auto search in local network
This area shows the network information and the number of target IP addresses of the network to which the
selected network adapter belongs. Click the [Execute] button to start a search. The results of the search
appear in the Result of searching area.
The Result of searching area lists only IP addresses that replied.
Shows the network information of the network to which the network adapter belongs.
Shows the number of IP addresses to be searched. During a search, this shows the number of searched
IP addresses and the rate of progression.
Click the [Execute] button to start a search.
During the search, this button switches to [Stop]. You can click this button to terminate the search.
3 Result of searching area
Shows the results of a ping test or an auto search in local network (page 35).
Do not change the IP address and subnet mask of the selected network adapter during a search.
1
2
3