User Manual
Table Of Contents
- Contents
- What you can do using ProVisionaire Touch
- Operating requirements of the software
- Terms and concepts to understand
- Installation procedure
- Startup
- Basic process
- Operations for common settings
- About the menu bar
- Settings file management — the File Management button
- Selecting multiple widgets — Multi Select button
- Creating a custom panel — the Page Edit button
- Widget design
- Assigning parameters
- Switching pages — the Page Selection button (Control mode)
- Managing pages — the Page Management button (Design mode)
- Registering devices to control — the Device Management button
- Control panel settings — the Setup button
- Control panel information — the Information button
- Preparations before you make connections
- Troubleshooting
- About the software license
67
4. Enter each item, and tap [Done].
• Device Type: Tap [Select], and in the list that appears, select
the type of device that you want to register.
• Model: Tap [Select], and in the list that appears, select the
model name of the device that you want to register. The con-
tent of the list differs depending on the type selected in Type.
• Match Device By:
Choose whether to identify devices by
UNIT ID (in the case of the MRX, by RCSL) or by IP address.
If you specify a device whose UNIT ID cannot be set, this is
not shown, since only IP address is available. If you want to
control a device on a different subnet, select [IP Address].
• Unit ID: Tap [Select], and in the list that appears, select the
appropriate ID.
• IP Address: Enter the IP address that is assigned to the
device.
• Name: Tap [Enter device name], and enter a name (friendly
name) so you can identify the device.
• If you choose “MRX7-D” as the Model
The “Match Device By” field will be a choice of either RCSL or
IP Address. RCSL stands for “Remote Control Setup List”; if
you choose RCSL, the UNIT ID within the file is used to identify
the device.
The [Import from Remote Control Setup List] button appears.
Tapping the button displays the Remote Control Setup List in
the Documents folder.
From this list, select the file that you want to associate.
Use MRX Designer to create the Remote Control Setup List.
For details on creating the list, refer to the MRX Designer User
Guide.