User Manual
Table Of Contents
- Information
- About Yamaha LAN Monitor
- Contents
- Terminology
- Steps to use the software
- Software operating requirements
- Notes
- Notes regarding device detection
- Notes regarding SWX2100/SWR2100P series PoE switch detection
- Notes regarding the power supply interruption function for the Yamaha PoE switch
- Notes regarding a slave with the stack function enabled
- Notes on printing and print preview of the “Whole map”
- Notes regarding detection of Dante-enabled devices
- Notes regarding when using macOS10.15.x or later
- Installing and uninstalling Yamaha LAN Monitor
- Starting and exiting Yamaha LAN Monitor
- Yamaha LAN Monitor screen structure
- Network settings on the computer
- Basic operation
- Menu bar
- Toolbar and display area
- Main screen
- Web GUI
- Resources
- Troubleshooting
Main screen
Yamaha LAN Monitor for Mac User Guide
28
Port settings
Click the [Port settings] tab, and then click a port number to display the following setting items.
6 [Web GUI] button (shown only for a slave device with a Web GUI)
When you click this, the Web GUI of the device currently selected in the tree appears in the default browser.
In the Web GUI, you can configure basic settings for Yamaha switch and Yamaha wireless LAN access point
and manage them. For details, refer to “Logging in to the Web GUI” (page 33).
7 Button to show/hide device details
Click the button to switch whether device details are shown or hidden.
For Dante-enabled devices, the switch button is not shown.
8 Button to switch Stack ID (shown only for a slave device with stack function enabled)
When you click this, the port information of the device with the selected stack ID is displayed.
Tree view
This area shows the Yamaha switch, and Dante-enabled devices detected by Yamaha LAN Monitor. The device
name and the number of connected devices (slave devices only) are shown at the right of the icon; when you click
the open/close button [>] located at the left of the icon, the devices connected below that slave device are shown.
NOTE
This will not function until a Yamaha switch is found.
Restart
Restarts the switch.
Click the [Execute] button to display a “Restart” confirmation message.
Initialize
Initializes the switch.
Click the [Execute] button to display an “Initialize” confirmation message.
Basic functions
Configures the basic functions of the port.
Click the [Settings] button to display the “Basic functions” dialog box.
Tag VLAN
Configures the tag VLAN settings.
Click the arrow ( ) to display the [Settings] button. Click the [Settings] button to display the
“Tag VLAN” dialog box.
PoE power supply
Configures the PoE power supply settings.
This is displayed only for the SWX2110P-8G.
Click the [Settings] button to display the “PoE power supply” dialog box.