User Manual

Toolbar and display area
Yamaha LAN Monitor for Mac User Guide
23
• Link speed:
Shows the link speeds. The link speed between devices (the link speed for the
port of the higher device) is indicated by a colored connection line between the
device icons (the lime line in the right figure). The link speed indicated by each
color is described in the legend at the upper right of the screen.
3 Network configuration display area
Shows the information of slaves and equipment in the network.
The following information is available depending on the type of the device.
•Slave
Shows the name, MAC address, device name, and IP address
(as shown in the right figure). The IP address appears as a
hyphen (-) when the address cannot be obtained.
•Device
Shows the IP address, manufacturer, device name, and comment (as shown
in the right figure). The manufacturer, device name, and comment appear as
hyphens (-) when nothing is specified.
• Dante device
Shows the IP address, manufacturer, device name, and comment.
The comment appears as a hyphen (-) when no comment is specified. If Dante Control and Monitoring
has not been installed, Dante-enabled devices are identified as equipment, so the available information is
the same as for “Equipment.”
[Dante Controller] button
Starts the Dante Controller that is installed on the computer. Dante settings, such as patching, can be configured.
To display this button,Dante Control and Monitoring must be installed (page 7).
If Dante Controller is not installed (page 7), an error message appears.
For details on using Dante Controller, refer to the Dante Controller User Guide.