User Manual

Table Of Contents
List screen
Yamaha LAN Monitor for Mac User Guide
33
NOTE
When using the snapshot function, as well as the “Connected Devices” view (page 27), if a device saved in the snapshot is
no longer found, the corresponding device is shown in red. If a device that had not been saved previously is newly found,
the corresponding device is shown in blue.
7 “Setting” button
This button opens the “Device Settings” dialog (page 36).
“Firmware Update” tab
From this tab, you can update the firmware for devices being managed by LAN Monitor, and view information about
the firmware.
Only devices that support firmware update from LAN Monitor will be displayed in this screen.
When you select a device and then press the “Firmware Update” button, a dialog box will appear that confirms the
firmware update of all selected devices at once.
For details, refer to “Update firmware on multiple units at once” (page 42).
1 “Select all”
Press the button to check the checkboxes of all the displayed devices, and all the devices will be selected.
2 “Deselect all”
Press the button to remove the check from the checkboxes of all devices displayed, leaving all devices
unselected.
3 Number of items displayed and number of items selected
The number of devices displayed in the device list and the number currently selected will be displayed.
4 “Firmware Update”
Displays the dialog to update the firmware of the selected devices at once.
5 “Search” box
Narrows down the currently displayed device by string.
The behavior is equivalent to the “Switch / Wireless AP List” tab (page 31).
6 Device list
Displays a list of devices that support firmware update from LAN Monitor.
The items that will be displayed are as follows.
Check box
Used to select or deselect a device.
“Route”
The same contents as the “Switch / Wireless AP List” tab (page 31) will be displayed.
1 2 3