User Manual
Table Of Contents
- Yamaha LAN Monitor for Mac
- Table of contents
- 1. Introduction
- 2. Installing and uninstalling Yamaha LAN Monitor
- 3. Starting and exiting Yamaha LAN Monitor
- 4. Yamaha LAN Monitor screen structure
- 5. Network settings on the computer
- 6. Basic operation
- 7. Menu bar
- 8. Toolbar and display area
- 9. Map screen
- 10. List screen
- 11. Configuring the device
- 12. Update the firmware
- 13. Import/Export the CONFIG
- 14. Resources
- 15. Troubleshooting
- Yamaha LAN Monitor for Mac
14.4. Execution result of firmware/CONFIG bulk operation
The following are the execution results displayed when executing bulk firmware update and bulk
CONFIG import/export.
Result Descriptions
Completed The firmware update and CONFIG import/export processes
have been completed successfully.
Only transfer completed (revision
acquisition failed)
The firmware file transfer was completed but the updated
firmware revision could not be retrieved, so the firmware
may not have been applied correctly.
Check the application status of the firmware separately.
Only transfer completed (revision
mismatch)
The transfer of the firmware file is complete, but the
revision of the transferred firmware file and the updated
firmware revision are different.
Check the application status of the firmware separately.
Only transfer completed (File revision
unknown)
The transfer of the firmware file was completed, but it was
not confirmed that the firmware was applied correctly
because the revision of the transferred firmware file was
incorrect.
Check the application status of the firmware separately.
Skip The firmware update was not performed because the
revision of the firmware file you tried to transfer had
already been applied.
Aborted Firmware update or CONFIG import/export has been
canceled by user operation.
Failed (Timeout) A timeout occurred and the transfer of firmware or CONFIG
failed.
Check the connectivity of the device.
Failed (Application error) An application error has occurred and the transfer of
firmware or CONFIG has failed.
Failed (Busy) The transfer of firmware or CONFIG failed because other
processes are running on the device.
Failed (Invalid file) The transfer of firmware or CONFIG failed because the
selected file was invalid.
Failed (CONFIG doesn’t exist) The CONFIG did not exist on the device where you tried to
export the CONFIG.
The CONFIG of the device may have been deleted, or it may
be in a factory default state.
Failed (Access permission error) CONFIG could not be accessed because the agent is running
in DANTE mode or for some other reason.
Failed (Unknown error) Transfer of firmware or CONFIG failed due to reasons other
than the above.
14. Resources
Yamaha LAN Monitor for Mac User Guide | 73