User Manual

14.7.5. “External Events” dialog box
Click the [Tools] button on the device sheet and then click [External Events…] to open this.
Here you can make settings for a command that will be transmitted to the network to which the Dante connector
or NETWORK connector is connected. This command can be triggered by recalling a preset on the MTX; or by
input from GPI IN; or by operation of an external device such as a DCP unit.

Only commands are transmitted, and any reply to the commands will be discarded.
You can set up to 20 events. You can set up to 5 commands per event.
•
Menu button( )
Click this button to execute the following functions.
◦ [Copy Event]
Copies the contents of the selected event to the copy buffer.
◦ [Copy All Event]
Copies the contents of all events to the copy buffer.
◦ [Paste Event]
Overwrites the event settings in the copy buffer.
◦ [Clear Event]
Initializes the contents of the selected event.
◦ [Clear All Event]
Initializes the contents of all events.
•
[Event No.] list box
Specify the event number.
•
[Event Mode] list box
Specify whether the triggered command is the [On/Off] or [1shot] type.
When an event is assigned to the button on an external device, such as a DCP unit, each command type
will cause the following operation:
◦ [On/Off]
Pressing the assigned button repeatedly will cause the MTX to transmit the On command and Off
command alternately.
◦ [1shot]
Pressing the assigned button will cause the MTX to transmit the programmed command.
•
[Event Name] text box
Specify the name of the event.
14. Audio Processors : MTX5-D/MTX3
200 | ProVisionaire Design User Guide