User Manual

26.3.3. DCP component: Settings dialog (knob)
•
[Parameter]
Operate the parameters with the knobs.
Parameters can be registered in the following ways.
Registration source Registration method
Component Editor While pressing and holding down <Ctrl>, drag and drop
a parameter to the green area of the "Settings" dialog
box.
"Parameters" area Drag and drop a parameter to the green area of the
"Settings" dialog box.
•
[Parameter Range]
You can set the movable range with Lower Limit and Upper Limit.
Click Lower Limit/Upper Limit to display the controls.
◦ [Mute Enable] check box
If this option is selected, the Mute state (–∞ dB) will be enabled if the level is lowered below the
value specified by [Lower Limit].
•
[Nominal]
By specifying the nominal value, you can assign a specific LED position as the normal volume setting. For
example by specifying the center LED as the volume setting for normal use and setting the maximum
value to the maximum volume that is allowable for the system, you can prevent damage to the system
26. DCP
330 | ProVisionaire Design User Guide