User Manual
Table Of Contents
- Notice regarding data copyright
- Notice regarding the content of this user guide
- Contents
- Chapter 1. An overview of MTX-MRX Editor
- An audio system control network
- Terms used in this user guide
- Data handled by MTX-MRX Editor
- Connection requirements for an MTX/MRX system
- MTX/MRX system configuration examples
- What are YDIF connections? (Cascade mode and Distribution mode)
- What are Dante connections? (Daisy-chain connection and Star connection)
- Patching
- Workflow
- About the screens
- Moving between screens
- Chapter 2. Menu bar and tool buttons
- Chapter 3. Project screen
- Chapter 4. System screen
- Chapter 5. Online and Synchronization
- Chapter 6. Presets
- Chapter 7. Dialog boxes/Software applications
- “Startup” dialog box
- “Network Setup” dialog box
- “Device Information” dialog box
- “Match Device by IP Address” dialog box
- “MTX Configuration” dialog box
- “Dante Information” dialog box
- “Word Clock” dialog box
- “Clock” dialog box
- “Daylight Saving Time” dialog box
- “Scheduler” dialog box
- “Remote Control” dialog box
- “External Events” dialog box
- “Digital Control Panel” dialog box
- “Wireless DCP” dialog box
- “MCP1” dialog box
- “PIN Setup” dialog box
- “Label” dialog box
- “Re-size Image” dialog box
- “PGM1/PGX1” dialog box
- “PGM1 Label Creator” application
- “GPI” dialog box
- “GPI Calibration” dialog box
- “Security Settings” dialog box
- “Project Information” dialog box
- “Configuration Diagram” dialog box
- “Get Log” dialog box
- “Sampling Rate Converter” dialog box
- “Input Source/Redundant” dialog box
- Appendix
“I/O” screen Chapter 4. System screen
MTX-MRX Editor User Guide
112
“I/O” screen
In this screen you can make settings related to the HA (head amp) of the MTX’s analog input, and for
the MTX’s digital output.
You can also make settings to specify whether a pilot tone is output from digital output.
When the PILOT TONE [ON] button is on, a pilot tone is output to channels whose digital output’s
[PT] button is on.
To specify the XMV units that receive the pilot tone, access the “Project” screen > [Device] tab, and
click the [INPUT SOURCE] button to make settings for redundancy.
Signal flow
1
2
3
45
INPUT
1-8
+48V
AD
+
-
+48V
GAIN
ME TER
INPUT
8
16
16
YDIF MODE
CASCADE MODE
or DISTRIBUTION MODE
YDIF
OUT
PILOT TONE
ON
LEVEL
Sine Wa ve
20.0kHz
To YDIF OUT
To DANTE OUT
From PILO T TONE
SUM
16
DANTE
OUTPUT
GAIN
POL A RITY
SUM
From PILO T TONE
16