User Manual
Table Of Contents
- Notice regarding data copyright
- Notice regarding the content of this user guide
- Contents
- Chapter 1. An overview of MTX-MRX Editor
- An audio system control network
- Terms used in this user guide
- Data handled by MTX-MRX Editor
- Connection requirements for an MTX/MRX system
- MTX/MRX system configuration examples
- What are YDIF connections? (Cascade mode and Distribution mode)
- What are Dante connections? (Daisy-chain connection and Star connection)
- Patching
- Workflow
- About the screens
- Moving between screens
- Chapter 2. Menu bar and tool buttons
- Chapter 3. Project screen
- Chapter 4. System screen
- Chapter 5. Online and Synchronization
- Chapter 6. Presets
- Chapter 7. Dialog boxes/Software applications
- “Startup” dialog box
- “Network Setup” dialog box
- “Device Information” dialog box
- “Match Device by IP Address” dialog box
- “MTX Configuration” dialog box
- “Dante Information” dialog box
- “Word Clock” dialog box
- “Clock” dialog box
- “Daylight Saving Time” dialog box
- “Scheduler” dialog box
- “Remote Control” dialog box
- “External Events” dialog box
- “Digital Control Panel” dialog box
- “Wireless DCP” dialog box
- “MCP1” dialog box
- “PIN Setup” dialog box
- “Label” dialog box
- “Re-size Image” dialog box
- “PGM1/PGX1” dialog box
- “PGM1 Label Creator” application
- “GPI” dialog box
- “GPI Calibration” dialog box
- “Security Settings” dialog box
- “Project Information” dialog box
- “Configuration Diagram” dialog box
- “Get Log” dialog box
- “Sampling Rate Converter” dialog box
- “Input Source/Redundant” dialog box
- Appendix
“Device Information” dialog box Chapter 7. Dialog boxes/Software applications
MTX-MRX Editor User Guide
167
•Battery
Shows the remaining battery amount for a device that contains a battery.
EMPTY: The remaining amount is 0–0.5V. Immediately stop using the unit, and
contact a Yamaha service center.
Low: The remaining amount is 0.5–2.5V. Contact a Yamaha service center as
soon as possible.
OK: The remaining amount is 2.5–3.5V. There is no problem.
N/A: The device does not contain a battery.
● [Update Firmware] button
Updates the firmware.
Click this button to open the “Update Firmware” dialog box.
• If the “Select Folder” dialog box opens, select the folder that contains the update file, then
click the [OK] button.
• To update the firmware of the R series (AD/DA) or Tio1608-D, use the Windows software
application R Remote.
● [Set IP Address] button
Specifies the device’s IP address and subnet mask.
When you click this button, the “IP Address” dialog box will appear.
● [Refresh] button
Searches again for devices on the network.
This cannot be clicked while an update is in progress.
● [Close] button
Closes the dialog box.
This cannot be clicked while an update is in progress.
NOTE