User Manual
Table Of Contents
- Notice regarding data copyright
- Notice regarding the content of this user guide
- Contents
- Chapter 1. An overview of MTX-MRX Editor
- An audio system control network
- Terms used in this user guide
- Data handled by MTX-MRX Editor
- Connection requirements for an MTX/MRX system
- MTX/MRX system configuration examples
- What are YDIF connections? (Cascade mode and Distribution mode)
- What are Dante connections? (Daisy-chain connection and Star connection)
- Patching
- Workflow
- About the screens
- Moving between screens
- Chapter 2. Menu bar and tool buttons
- Chapter 3. Project screen
- Chapter 4. System screen
- Chapter 5. Online and Synchronization
- Chapter 6. Presets
- Chapter 7. Dialog boxes/Software applications
- “Startup” dialog box
- “Network Setup” dialog box
- “Device Information” dialog box
- “Match Device by IP Address” dialog box
- “MTX Configuration” dialog box
- “Dante Information” dialog box
- “Word Clock” dialog box
- “Clock” dialog box
- “Daylight Saving Time” dialog box
- “Scheduler” dialog box
- “Remote Control” dialog box
- “External Events” dialog box
- “Digital Control Panel” dialog box
- “Wireless DCP” dialog box
- “MCP1” dialog box
- “PIN Setup” dialog box
- “Label” dialog box
- “Re-size Image” dialog box
- “PGM1/PGX1” dialog box
- “PGM1 Label Creator” application
- “GPI” dialog box
- “GPI Calibration” dialog box
- “Security Settings” dialog box
- “Project Information” dialog box
- “Configuration Diagram” dialog box
- “Get Log” dialog box
- “Sampling Rate Converter” dialog box
- “Input Source/Redundant” dialog box
- Appendix
“Match Device by IP Address” dialog box Chapter 7. Dialog boxes/Software applications
MTX-MRX Editor User Guide
175
1 [Distinguish devices by IP Address] check box
If this check box is selected, devices are distinguished by their IP address, not their
UNIT ID.
2 “IP Address Range Finder” area
If it is OK for the IP addresses to be consecutive, you can use this to calculate the
IP addresses for assignment.
• [IP Address]
Enter the IP address that you want to use.
• [Subnet Mask]
Select the subnet mask. For the subnet masks that can be selected, refer to the
“IP Address” dialog box.
• [Find Range] button
When you click this, the range that can be specified is calculated from the IP address
and subnet mask that you input.
•“Range”
Shows the calculated range of IP addresses.
3 [Apply IP Address] button
When you click this, the IP address calculated in the “IP Address Range Finder” area is
applied to the devices in the system tab.
1
2
3
4
5 6 7