User Manual
Table Of Contents
- Notice regarding data copyright
- Notice regarding the content of this user guide
- Contents
- Chapter 1. An overview of MTX-MRX Editor
- An audio system control network
- Terms used in this user guide
- Data handled by MTX-MRX Editor
- Connection requirements for an MTX/MRX system
- MTX/MRX system configuration examples
- What are YDIF connections? (Cascade mode and Distribution mode)
- What are Dante connections? (Daisy-chain connection and Star connection)
- Patching
- Workflow
- About the screens
- Moving between screens
- Chapter 2. Menu bar and tool buttons
- Chapter 3. Project screen
- Chapter 4. System screen
- Chapter 5. Online and Synchronization
- Chapter 6. Presets
- Chapter 7. Dialog boxes/Software applications
- “Startup” dialog box
- “Network Setup” dialog box
- “Device Information” dialog box
- “Match Device by IP Address” dialog box
- “MTX Configuration” dialog box
- “Dante Information” dialog box
- “Word Clock” dialog box
- “Clock” dialog box
- “Daylight Saving Time” dialog box
- “Scheduler” dialog box
- “Remote Control” dialog box
- “External Events” dialog box
- “Digital Control Panel” dialog box
- “Wireless DCP” dialog box
- “MCP1” dialog box
- “PIN Setup” dialog box
- “Label” dialog box
- “Re-size Image” dialog box
- “PGM1/PGX1” dialog box
- “PGM1 Label Creator” application
- “GPI” dialog box
- “GPI Calibration” dialog box
- “Security Settings” dialog box
- “Project Information” dialog box
- “Configuration Diagram” dialog box
- “Get Log” dialog box
- “Sampling Rate Converter” dialog box
- “Input Source/Redundant” dialog box
- Appendix
“MTX Configuration” dialog box Chapter 7. Dialog boxes/Software applications
MTX-MRX Editor User Guide
178
● [OUTPUT] tab
In this tab, you can make settings related to outputs.
•MATRIX BUS SETUP
Here you can make settings for the matrix buses. These settings will affect the
“MATRIX” screen.
MONO x2...............The input channels will be treated as two monaural channels.
STEREO .................The input channels will be treated as a single stereo pair.
If the MTX/MRX system’s YDIF mode is Cascade mode, the parameters will be shared
in common by all MTX units in the MTX/MRX system.
• CASCADE MODE
Here you can specify the zone input source for each matrix. This setting cannot be
made in Distribution mode.
• OUTPUT CHANNEL SETUP
Here you can specify the type of output channel speaker processor (1WAYx2 or
2WAY). The settings here will affect the channel strip of the “MAIN” screen.
On Off
The matrix out of all MTX units will
be mixed for each matrix. That mixed
signal will be used as the input to the
zone.
Instead of using the mix from the bus,
the matrix out will be used as the
input for the zone.
NOTE
BUS1 BUS2
01 MTX3
Matrix1
ZONE1
02 MTX3
Matrix1
ZONE1
03 MTX3
Matrix1
ZONE1
04 MTX3
Matrix1
ZONE1
BUS1 BUS2
01 MTX3
Matrix1
Local Mix
ZONE1
02 MTX3
Matrix1
ZONE1
03 MTX3
Matrix1
ZONE1
04 MTX3
Matrix1
ZONE1