User Manual
Table Of Contents
- Notice regarding data copyright
- Notice regarding the content of this user guide
- Contents
- Chapter 1. An overview of MTX-MRX Editor
- An audio system control network
- Terms used in this user guide
- Data handled by MTX-MRX Editor
- Connection requirements for an MTX/MRX system
- MTX/MRX system configuration examples
- What are YDIF connections? (Cascade mode and Distribution mode)
- What are Dante connections? (Daisy-chain connection and Star connection)
- Patching
- Workflow
- About the screens
- Moving between screens
- Chapter 2. Menu bar and tool buttons
- Chapter 3. Project screen
- Chapter 4. System screen
- Chapter 5. Online and Synchronization
- Chapter 6. Presets
- Chapter 7. Dialog boxes/Software applications
- “Startup” dialog box
- “Network Setup” dialog box
- “Device Information” dialog box
- “Match Device by IP Address” dialog box
- “MTX Configuration” dialog box
- “Dante Information” dialog box
- “Word Clock” dialog box
- “Clock” dialog box
- “Daylight Saving Time” dialog box
- “Scheduler” dialog box
- “Remote Control” dialog box
- “External Events” dialog box
- “Digital Control Panel” dialog box
- “Wireless DCP” dialog box
- “MCP1” dialog box
- “PIN Setup” dialog box
- “Label” dialog box
- “Re-size Image” dialog box
- “PGM1/PGX1” dialog box
- “PGM1 Label Creator” application
- “GPI” dialog box
- “GPI Calibration” dialog box
- “Security Settings” dialog box
- “Project Information” dialog box
- “Configuration Diagram” dialog box
- “Get Log” dialog box
- “Sampling Rate Converter” dialog box
- “Input Source/Redundant” dialog box
- Appendix
“Digital Control Panel” dialog box Chapter 7. Dialog boxes/Software applications
MTX-MRX Editor User Guide
205
“Settings” dialog box
You can access this dialog box from the “Digital Control Panel” dialog box, the “Wireless
DCP” dialog box, or the “GPI” dialog box.
For details on the “Settings” dialog box that is accessed from the “Preset” dialog box and the
“Scheduler” dialog box, refer to “Settings” dialog box in chapter 6.
● [FUNCTION] list
Selects the function to be controlled. If you select [No Assign], no function will be assigned.
The available range in [FUNCTION] and the contents of [DEVICE], [PARAMETER1],
and [PARAMETER2] will depend on the function that you selected. The options
shown in the lower half will also change.
For details on the functions and the display, refer to List of settings in “Settings” dialog
boxes.
● [DEVICE] list
Select the device that you want to change. These are shown in order of UNIT ID and
model name.
● [PARAMETER1] list / [PARAMETER2] list
Specify the parameters of the function.
For details on these parameters, refer to List of settings in “Settings” dialog boxes.
● [OK] button
Saves the settings and closes the dialog box.
● [Cancel] button
Closes the dialog box without saving the changes.
NOTE