User Manual

“MCP1” dialog box Chapter 7. Dialog boxes/Software applications
MTX-MRX Editor User Guide
211
● [Dimmer & Lock] tab
Here you can make settings for the brightness of the MCP1’s display and switches, and
for panel lock.
• [Brightness] check box
If this check box is selected, the brightness and contrast of the display, and the
brightness of the switches, can be changed when a preset recalls the currently-edited
library item.
[LCD Brightness] specifies the brightness of the display. Higher values will make the
display brighter.
[LCD Contrast] specifies the display’s contrast. Higher values produce a greater
difference between light and dark.
[LED Brightness] specifies the brightness of the switches. Higher values will make
the switches brighter.
If the check box is cleared, the drop-down menu is grayed out and you will be unable
to set the brightness.
• [Panel Lock] check box
If this check box is selected, the MCP1 panel will be locked when the library item is
recalled by a preset.
If the [Enable Temporary Unlocking] check box is selected, pressing and holding
down the MCP1’s home switch for two seconds or longer will unlock the panel.
If the [Enter PIN to unlock MCP1] check box is selected, pressing and holding down
the MCP1’s home switch for two seconds or longer will then require the PIN code
specified in [Panel Unlock PIN:] of the “PIN CODE” dialog box to be entered on the
MCP1.
•[Waiting Time]
Specifies the time from the last operation until the unit enters inactive mode or the
panel is locked.