User Manual
Table Of Contents
- Notice regarding data copyright
- Notice regarding the content of this user guide
- Contents
- Chapter 1. An overview of MTX-MRX Editor
- An audio system control network
- Terms used in this user guide
- Data handled by MTX-MRX Editor
- Connection requirements for an MTX/MRX system
- MTX/MRX system configuration examples
- What are YDIF connections? (Cascade mode and Distribution mode)
- What are Dante connections? (Daisy-chain connection and Star connection)
- Patching
- Workflow
- About the screens
- Moving between screens
- Chapter 2. Menu bar and tool buttons
- Chapter 3. Project screen
- Chapter 4. System screen
- Chapter 5. Online and Synchronization
- Chapter 6. Presets
- Chapter 7. Dialog boxes/Software applications
- “Startup” dialog box
- “Network Setup” dialog box
- “Device Information” dialog box
- “Match Device by IP Address” dialog box
- “MTX Configuration” dialog box
- “Dante Information” dialog box
- “Word Clock” dialog box
- “Clock” dialog box
- “Daylight Saving Time” dialog box
- “Scheduler” dialog box
- “Remote Control” dialog box
- “External Events” dialog box
- “Digital Control Panel” dialog box
- “Wireless DCP” dialog box
- “MCP1” dialog box
- “PIN Setup” dialog box
- “Label” dialog box
- “Re-size Image” dialog box
- “PGM1/PGX1” dialog box
- “PGM1 Label Creator” application
- “GPI” dialog box
- “GPI Calibration” dialog box
- “Security Settings” dialog box
- “Project Information” dialog box
- “Configuration Diagram” dialog box
- “Get Log” dialog box
- “Sampling Rate Converter” dialog box
- “Input Source/Redundant” dialog box
- Appendix
“Security Settings” dialog box Chapter 7. Dialog boxes/Software applications
MTX-MRX Editor User Guide
228
❑ “Security Settings” dialog box
On the MTX/MRX system, you can specify a PIN code (numeric password) for security.
● [Security] check box
If this check box is selected, the “Security” dialog box will appear when the project file
starts.
If this check box is cleared, all users will be able to make changes in MTX-MRX Editor.
● [PIN Code]
If the [Security] check box is selected, enter the PIN code (four single-byte numerals).
You cannot enter anything other than single-byte numerals, nor can you enter a blank
PIN code.
• The PIN code can be viewed in this dialog box. Make sure that it is not seen by
another user.
• If you forget the PIN code, you will be unable to open the corresponding project file.
● [OK] button
Updates the settings and closes the dialog box.
If you are online, these settings will be transmitted to all MTX/MRX units in the
project.
If you are offline, they will be transmitted when you go online.
● [Cancel] button
Closes the dialog box without updating the settings.
“Security” dialog box
When you open a project file for which a PIN code has been specified, the “Security”
dialog box appears.
Enter the PIN code, and click the [OK] button.
NOTE