User Manual

List of settings in “Settings” dialog boxes Appendix
MTX-MRX Editor User Guide
241
●If [FUNCTION] is [MTX Level Inc/Dec] or [MTX Send Level Inc/Dec]
(DCP switches only)
Use the switch to change the level or send level.
Select one of the following parameter types, and then make the appropriate setting.
If [FUNCTION] is [MTX Level Inc/Dec]
•Input Ch Level
•Fx RTN Level
•Matrix Out Level
•ZONE Out Level
•Output Ch Level
•1st Priority Mix Level
•2nd Priority Mix Level
•Input Ch DCA Group
•ZONE Out DCA Group
If [FUNCTION] is [MTX Send Level Inc/Dec]
•Input Ch Send Level
•Fx RTN Send Level
❍ [DEVICE]
Select the device that you want to change. These are shown in order of UNIT ID and
model name.
❍ [PARAMETER1]/[PARAMETER2]
Specifies the channel for which the level or send level will be raised or lowered. If
[FUNCTION] is [Send Level Inc/Dec], use [PARAMETER2] to set ZONE, Fx, and
ANC.
❍ [Inc]
If you select this option, pressing the switch repeatedly will raise the level or the send
level.
✦[Upper Limit]
Specifies the maximum level achieved when you press the switch.
✦[Minimum]
If the current parameter value is lower than the value specified here, pressing the
switch once will set the parameter to this value.