User Manual
Table Of Contents
- Notice regarding data copyright
- Notice regarding the content of this user guide
- Contents
- Chapter 1. An overview of MTX-MRX Editor
- An audio system control network
- Terms used in this user guide
- Data handled by MTX-MRX Editor
- Connection requirements for an MTX/MRX system
- MTX/MRX system configuration examples
- What are YDIF connections? (Cascade mode and Distribution mode)
- What are Dante connections? (Daisy-chain connection and Star connection)
- Patching
- Workflow
- About the screens
- Moving between screens
- Chapter 2. Menu bar and tool buttons
- Chapter 3. Project screen
- Chapter 4. System screen
- Chapter 5. Online and Synchronization
- Chapter 6. Presets
- Chapter 7. Dialog boxes/Software applications
- “Startup” dialog box
- “Network Setup” dialog box
- “Device Information” dialog box
- “Match Device by IP Address” dialog box
- “MTX Configuration” dialog box
- “Dante Information” dialog box
- “Word Clock” dialog box
- “Clock” dialog box
- “Daylight Saving Time” dialog box
- “Scheduler” dialog box
- “Remote Control” dialog box
- “External Events” dialog box
- “Digital Control Panel” dialog box
- “Wireless DCP” dialog box
- “MCP1” dialog box
- “PIN Setup” dialog box
- “Label” dialog box
- “Re-size Image” dialog box
- “PGM1/PGX1” dialog box
- “PGM1 Label Creator” application
- “GPI” dialog box
- “GPI Calibration” dialog box
- “Security Settings” dialog box
- “Project Information” dialog box
- “Configuration Diagram” dialog box
- “Get Log” dialog box
- “Sampling Rate Converter” dialog box
- “Input Source/Redundant” dialog box
- Appendix
List of settings in “Settings” dialog boxes Appendix
MTX-MRX Editor User Guide
249
●If [FUNCTION] is [Legacy - MTX Source Select w/knob]
(only for switches of a DCP equipped with knobs)
You can control the send on/off for multiple channels via switches, and control the send
level for any channel via knobs.
If you assign the same source to multiple DCP units and then change the settings on
one of the DCP units, the changes will not be updated on other DCP units. Each DCP
unit will retain the settings (LED status and knob assignments) that were made on it.
❍ [DEVICE]
Select the device that you want to change. These are listed in order of UNIT ID and
model name.
❍ [PARAMETER1]/[PARAMETER2]
In the [PARAMETER1] column, select the target ZONE.
In the [PARAMETER2] column, click to the left of the channel name to select
ON, OFF, or IGNORE for the desired channels. The ON/OFF/IGNORE setting can
be applied to multiple channels simultaneously. If you select an ON channel, the
bottom half of the dialog box will display parameter fields related to the knobs.
❍ [Assign the send level to:] box
Enables you to select a knob that will control the send level of the currently-selected
channel.
Only one channel can be assigned to a knob.
❍ [Parameter Range]/[Nominal]/[Knob]
Enable you to make a setting for the knob that has been specified in the [Assign the
send level to:] box. For details about the settings, refer to If [FUNCTION] is [MTX
Level] for knobs/sliders.
NOTE