User Manual
Table Of Contents
- Contents
- An overview of MRX Designer
- Screen structure
- Basic use of MRX Designer
- Menu bar
- Tool buttons
- Shortcut keys
- Design sheet
- “Parameter Sets” area
- “Parameter Link Group” area
- “Gang Edit Group” area
- “Properties” area
- Components and the component editor
- Editing the parameters
- Acoustic Echo Canceller (AEC)
- Ambient Noise Compensator (ANC)
- Audio Detector
- Auto Gain Controller (AGC)
- Combiner
- Delay
- Dynamics
- Effect
- EQ
- Fader
- Feedback Suppressor
- Filter
- Inputs/Outputs
- Meter
- Mixer
- Oscillator
- Paging
- Polarity
- Revolabs Control
- Router
- Source Selector
- Speaker Processor
- Speech Privacy
- Text
- Transmitter/Receiver
- User Defined Block
- Dialog boxes and applications
- “Print” dialog box
- “Install Speech Privacy File” dialog box
- “File Transfer” application
- “PGM1 Label Creator” application
- “Compile” dialog box
- “Snapshot Group” dialog box
- “Remote Control Setup List” dialog box
- “External Events” dialog box
- “GPI” dialog box
- “Digital Control Panel” dialog box / “Wireless DCP” dialog box / “MCP1” dialog box
- “PGM1/PGX1” dialog box
- “Port Name” dialog box
- List of settings in “Settings” dialog boxes
- Context menus
- Troubleshooting
Duplicating an input port name
MRX Designer User Guide
25
❑ Duplicating an input port name
If you want to use the signal name as the port name, it is convenient to duplicate the port name.
Here we explain how to automatically duplicate the input port name.
In general, the input port name is automatically duplicated to the input port of the connection-
destination component, but the following exceptions apply.
• For a mixer-type component or a component that has only an output, the output port name is
duplicated to the input port of the connection-destination.
• If the duplication-source port name is blank, it is not automatically duplicated.
If the port name has already been specified, the port name is overwritten by the automatic
duplication.
• Automatically duplicating the port name when components are connected
If [Tools] menu →[Duplicate Port Label] has a check mark, the port name is
automatically duplicated when you make a connection between components.
• Duplicating the port name of components along the signal path
In the context menu that appears when you right-click a port or component, choose
[Duplicate Port Label - to the right] or [Duplicate Port Label - to the left]; the input
port name is duplicated to the input port of the following or preceding components.
However if a mixer-type component exists within this path, duplication stops at the
mixer-type component.
NOTE