User Manual

English

MSP7 STUDIO/MSP5 STUDIO/SW10 STUDIO Owner’s Manual

SW10 STUDIO

1 POWER switch

Tur ns power to the speaker on or off. When the power is

turned on the POWER indicator (8) on the front panel will

light green.

2 AC IN Connector

Connect the supplied power cable here. First connect the

power cord to the subwoofer, then insert the power cord plug

into the AC outlet.

3 PHASE switch

Selects a phase of output sound from the SW10 STUDIO.

You will usually set this switch to "NORM". However, the "REV."

setting may improve low-range response, depending on the

type and location of the entire speaker system. Try both set-

tings and select the one that produces the best low-end

sound.

4 HIGH CUT control

Use the HIGH CUT control to set the cutoff frequency of the

signal output from the SW10 STUDIO from 40 Hz to 120 Hz.

5 LEVEL control

Adjusts the overall output level.

6 INPUT L/R/SUBWOOFER connector

These are balanced XLR-type input connectors. Three differ-

ent signals can be simultaneously input via these connectors.

The input signals are mixed before being sent to the sub-

woofer.

7 OUTPUT L/R/SUBWOOFER connector

These XLR-type balanced output connectors output the sig-

nals received at the INPUT L/R/SUBWOOFER connectors,

respectively.

8 POWER indicator

When the power is turned on the POWER indicator will light

green. The power indicator will ﬂash red to indicate clipping.

43 5

SW10 STUDIO

(Rear Panel)

(Front Panel)