User Guide

4. Setting the monitor and meter sections

Set the PHONES SELECT switch to the “STEREO”

position.

Set the PHONES volume to around “7”.

Make sure the METER SELECT switch is in the “4

TRK” position.

5. Adjusting the input level

Set all of the input switches to the MIC/LINE

position.

Set the MASTER fader to “7”.

Set the PAN controls for all channels between the

center and the extreme “L" position, as shown.

Push the input fader for channel 1 up to “7”.

When the drums start playing, slide the gain con-

trol for channel 1 towards the “MIC”, direction, stop-

ping when the “+3” indicator on the far left level

meter flashes occasionally on the sound peaks.

Pull the input fader for channel 1 back down to “0”.

-The proper input level for channel 1 is now set.—

Set the input fader for channel 2 to “7”.

While the drums are being played, slide the gain con-

trol for channel 2 towards the “MIC” direction, stop-

ping when the “+3” indicator on the far left level

meter flashes occasionally on the sound peaks.

Pull the input fader for channel 2 back down to “0’:

-The proper input level for channel 2 is now set.-

Set the input levels for channels 3 and 4 the same

way.