User Manual

Example 5) A system using the PGM1 for paging
MTX Setup Manual
140
 OUTPUT settings
In OUTPUT you can make the following settings.
Port select button
Click this to open the “Output Patch” dialog box. For this example, apply the fol-
lowing changes. After making the settings, click the [Close] button.
Port / External Device parameter access button
When you click this button, the MTX output jack parameter edit screen will
appear as a popup.
DELAY / Room EQ
Click this to move to a screen where you can set delay and room EQ.
Speaker processor
Click this to switch to the “CHANNEL EDIT” screen. Make the appropriate set-
tings for the speakers that will be connected.
[ON] button
This button turns the channel on/off. Turn off unused channels.
Fader
This adjusts the output level.
Channel name
You can double-click this to edit the name.
In this example, names have been assigned as follows.
CH1 through CH8 DANTE 1 through DANTE 8
CH9 through CH16
No assignment (click an assigned button to specify no
assignment)
NOTE
The pre-installed library contains speaker processor files that are appropriate for the
response of various speakers. By using these files you can make speaker processor set-
tings easily.
OUT1 Luxury
OUT2 Casual1
OUT3 Casual2
OUT4 Casual3
OUT5 Event Space
OUT6 Food Court
OUT7 Entrance
OUT8 Restrooms
Port select button
Port / External
Device parameter
access button
[ON] button
Fader
Channel name
DELAY / Room EQ
Speaker processor