User Manual

13.4. Basic use of ProVisonaire Designer
1. From the “Components” area at the left, drag the component that you want to use and drop it on the
design sheet.
If you drop a component that has multiple candidates such as channels, the candidates are displayed; select the
one that you want to use as necessary.

Double-click on a component in the “Components” area to select Stamp mode; in this mode,
components are placed successively each time you click the design sheet. To cancel Stamp
mode, press <Esc> or click any component in the list.
2.
To make a connection, drag the of a component and drop it on the of another component.
For details, refer to Connecting ports.
3. Double-click a component or right-click it and choose “Open Component Editor”; the component editor
opens, allowing you to operate the parameters.
13. Audio Processors : DME7
ProVisionaire Design User Guide | 117