User Manual

13.13. "Parameters" area
This area displays information about the component that is currently selected in the Design sheet (Audio layer or
Control).
The upper part of this area indicates the signal processing capacity of each component as a percentage.
The lower part of this area lists the parameters for the component currently selected in the upper part.
If you add a check mark to the check box in the Control PINs column, you will be able to control the
corresponding parameter in the Control layer.
From this area, you can assign components and parameters to a parameter set, Remote Control Setup List, GPI
dialog box, MIDI dialog box, and DCP component. For more information on how to assign them, refer to the
section for the corresponding dialog box or screen.
•
Components
Lists the components currently selected in the sheet.
◦ Processing
Indicates the resources to be processed as a percentage.
•
Parameters
Lists the parameters for the component currently selected in the upper part.
◦ Control PINs
If you add a check mark to the check box in this column, you will be able to control the
corresponding parameter in the Control layer.
Immediately after you add a check mark, the corresponding audio component will be placed in the
Control layer.
13. Audio Processors : DME7
ProVisionaire Design User Guide | 143