User's Manual

Recall Filter setting screen Chapter 6. Presets
MTX Editor User’s Manual
136
•[ZONE] button
If this is on, the following settings will be recalled.
• 1st Priority’s Priority Source, Mix Level, and Ducker
• 2nd Priority’s Priority Source, Mix Level, and Ducker
•ANC
•Zone name
In the “MTX Configuration” dialog box, if [INPUT PORT SETUP] is changed from
“MONO x2” to “STEREO,” the setting of the [ZONE] button will follow the odd-
numbered zone.
• [ZONE OUT] button
If this is on, the ZONE Out Level and on/off (mute) will be recalled.
• [DCA] button (ZONE side)
If this is on, the following settings will be recalled.
• ZONE Out’s channel assignment to DCA or mute group
• Master level of the DCA group
• Master mute of the mute group
• [ROUTER] button
If this is on, the router settings will be recalled.
• [LEVEL]/[OUTPUT] buttons
If the [LEVEL] button is on, the output channel level and on/off (mute) settings will
be recalled.
If the [OUTPUT] button is on, the Room EQ, Delay, and Speaker Processor settings
will be recalled.
These can be specified individually for each channel.
• [OUT PATCH] button
If this is on, the output patch settings and output channel names will be recalled.
• [OUT PORT] button
If this is on, the output port’s output gain and polarity settings will be recalled.
• [EXT. I/O YDIF] button
If this is on, settings for the audio that is output from the MTX to YDIF when in
Distribution mode will be recalled.
• [DCP] button
If this is on, the parameter assignments of the DCP (digital control panel) unit
connected to the MTX will be recalled. The button shows the ID of the DCP.
• [Wireless DCP] button
If this is on, the settings of the Wireless DCP will be recalled. If eight Wireless DCP
units are connected, eight units will be affected by the on/off setting.
NOTE